i tried this all methods and no hex code is given from blue star gmail.com@groups.io> wrote:

Are you working in Simpl or CH? I work in Simpl and use a Serial to Analog 16bit, take that analog value and feed it into a keypad decoder 12 module. Some other small logic after that, but the keypad

Resolved - had an outdated .clz - Jeff at CC flagged it

Did you try calling their NJ distributor? * * Stirling Communications Supply Co. * 29 Poplar Drive * 07980 * Stirling, New Jersey * 908-604-9360 ( tel:908-604-9360 ) * www.stirlingcomm.com (

I am using TV Presets Profile Manager v2.0, TV Presets CRPC Interface v2.0 and TV Presets Channel Control v1.0 and when sending out channel numbers to IR Driver I am getting duplicate Numbers on

DM and we can check it out. Nicolasfreda at Hotmail NFH

I am looking for someone, that helps me (not for free) with converting my project. I don't have actual SIMPL and VTPro, but have converted VTPro project to Smart Graphics on my old VTPro, so now I

Does anyone have infrared  codes for Vogel’s motorized tv mount.  on site and don’t have a ir learner with me.  Thanks for your help

Have you tried pulse IR? Is that IR command a multi-mode code? Do you have the source HEX code anywhere from Blue Star that you can try pasting in as opposed to learning it?

Anyone know how to fix this syntax error? This S+ module fails to compile based on this line: Module is: Lutron HomeWorks QSX Single SetPoint 3rd Party HVAC Control written by Control

OVRC has it's quirks, but if you put a Pro Hub on-site it usually gets the job done for me. That said, I also usually have remote desktop and/or VPN access to all my sites as well.

OK. I tried that, and it looks nice, but like my other previous attempts, I can't seem to tie it in to the right thing to make it go to the Start Page. I even tied it to a hidden button w/ a Digital

I am currently working on integrating a Blue Star cassette AC through IR in a boardroom for our client. I have learned the Blue Star AC remote model R11CG/E using the Crestron IR learner. However, I

Crestron has partnered with some software developer to provide an MDU property manager dashboard which can monitor all kinds of things with a pretty usable interface... I saw that a couple years ago

Sounds like an overscan issue; sounds like the switcher is presenting different EDID to the source than the TV directly is which you can usually fix either by copying the EDID from the sink (e.g. TV)

I haven't really had time to play with this so I haven't got the programming right for it yet. But that's not the immediate problem.  I wanted to make sure it was actually working so I connected one

Right-Click on the Touchpanel in the device symbol section of SMW, then select 'Insert Device Extender' , then Activity Detection...

Activity extender huh? I don’t remember seeing that, but I’ll check it out on Monday. Thanks much. Jim

add an activity extender on the panel. Set it for 300s. This "activity" signal will remain high until the timer expires, but resets every time the panel is touched. Attach the output of the activity

It’s for a job. Basically, I have a “Start Page” with a full page size button that takes you to the login. It works fine, but once logged in and using the system, I want it to exit back to the